cable length
英 [ˈkeɪbl leŋθ]
美 [ˈkeɪbl leŋθ]
链（英国608英尺，美国720英尺）；电缆长度；线长；电线长度
英英释义
noun
- a nautical unit of depth
双语例句
- What is the maximum cable length between PC and camera ( s)?
再PC与照相机之间的电缆最长是多少？ - The basic theory of control method of unstressed cable length is illustrated. And this control method is employed for adjustment hanger force of self-anchored suspension bridge, order to conform with require of design.
阐述了无应力索长控制法的基本理论，并采用该控制方法调整自锚式悬索桥吊杆的内力值，使之符合设计要求。 - And then the effect of the change of cable length and span and the redistribution of dead load due to deformation on cable curve are analyzed.
分析了索长变化、跨度变化及主缆变形引起的恒载重分布对主缆线形的影响。 - The principle error of the TDR cable length measurement has also been analyzed. The influence of measuring numbers, counting pulse frequency and traveling wave velocity on measuring accuracy is analyzed.
分析了时域反射电缆测长的原理误差，研究了测量次数、计数脉冲频率、行波波速对测量精度的影响。 - Starting from the pre-stressed state, the tension force was calculated by controlling the initial cable length.
从预应力状态开始，通过控制索原长来追踪索在施工中的张拉力。 - First, the initial status and the initial cable length were calculated by means of controlling the cable force and the internal force of all members in the pre-stressed state were obtained at the same time.
首先通过控制索在预应力态下的张拉力求得零状态和索原长，并同时获得预应力态下所有单元的内力。 - Meanwhile, a decision method for determine an unknown cable length also recommend.
同时本文还向大家介绍一下未知电缆长度的电缆长度的简易判定方法。 - The calculation for construction control of the bridge is made with 3D Bridge program and the unstressed cable length method is used to control the final target status of the bridge in the spacial program.
施工控制计算采用3DBridge进行，并在空间程序上利用无应力索长法控制斜拉桥最终目标状态。 - The effects of the change of the cable length and that the change of span on the middle-span sag of the cable are analyzed, and a comparison is made between the Parabola Linear Approximate Calculation Method and the Segmental Catenary Nonlinear Exact Calculation Method.
分析了索股索长变化和跨度变化对索股跨中垂度的影响，并将抛物线线性近似计算方法和悬链线精确非线性计算方法进行了比较，发现两者计算结果较为接近。 - Under the conditions of given initial mid-span deflection, the cable length increment and load increment were obtained by means of the mid-span deflection increment.
在给定初始跨中挠度的条件下，利用跨中挠度增量值求得索长增量值与载荷增量值；